- 地址：
- 安國市南陽工業區
- 郵箱：
- 415130881@qq.com
- 電話：
- 18631165157
- 傳真：
- 0312-3427286
- 手機：
- 18631165157
渣漿泵不能啟動該怎么辦
故障原因：1)轉子卡死或有嚴重摩擦2)離心泵沒有關閉出口閥門，軸流泵沒有打開出口閥3)電壓太低4)過載安全保護電流調得太低5)平衡軸向力裝置失效6)軸承損壞
排除方法：1)檢查原因，消除2)離心泵關閉出口閥門啟動，軸流泵打開出口閥門啟動3)檢查原因，排除4)適當調高過載安全保護電流5)檢查原因、消除6)更換軸承 渣漿泵
What to do if the slurry pump can not be started
Fault cause: 1) the rotor is stuck or there is serious friction; 2) the outlet valve of centrifugal pump is not closed and the outlet valve of axial flow pump is not opened; 3) the voltage is too low; 4) the overload safety protection current is too low; 5) the balance axial force device fails; 6) the bearing is damaged
Troubleshooting: 1) check the cause and eliminate it; 2) close the outlet valve of centrifugal pump and start it; 3) check the cause and eliminate it; 4) properly raise the overload safety protection current; 5) check the cause and eliminate it; 6) replace the bearing slurry pump
